Installing Flexible Strip Lights
Adding Sensio flexible strip lighting to kitchen cabinets is easy. Follow the easy step-by-step instructions below or refer to the installation video. Either way, if you have additional questions, we are always standing by ready to help. Send us an email at Support@SensioAmerica.com or give us a call at 866-842-4360. Together, we'll get the job done!
INFORMATION
Tools & Materials
TOOLS

Drill

5/16" Drill Bit

Screwdriver Bit

Staple Gun

Tape Measure

Scissors

Pencil
MATERIALS

Flexible Strips

Driver Lead

Driver
Installation Instructions
STEP 1
Drill a 5/16" hole in the front corner of the underside of the cabinet.

STEP 2
Use a pencil to draw a line under the cabinet where you would like to place the lights.

STEP 3
Measure the line you drew to determine how long your run of flexible strips needs to be.

STEP 4
Plug the driver lead into one of the flexible strips and continue to plug additional strips into the end of each other to create a continuous run for the length you need. If necessary, you can create a more custom length by cutting the final strip anywhere there is a scissor mark indicated.

STEP 5
Peel off the 3M backing and adhere the strips along the pencil line you drew,
making sure the driver lead is on the side you drilled the hole.

STEP 6
Feed the driver lead wire through the hole and up along the inside front
corner of the cabinet.
NOTE: For this example, we will assume that you will be installing the driver
at the top of the cabinet, hidden from sight by crown molding.


STEP 7
Drill another 5/16" hole at the top front corner of the cabinet, feed the driver
lead through and connect it to the driver.
STEP 8
Use a staple gun to staple the wire in place along the inside front edge of the cabinet.
